CTX-200 - /GR 1 kg

This granular disinfectant product is characterized by very high stability against decomposition from sunlight. Even at higher concentrations it does not discolor plastic materials, and is therefore suitable for vinyl-lined pools.

Contains 90-100% dichloroisocyanuric acid.

 

Dosage:

Initial dosing: 1.5 g/m3, after 2 hours adjust the water pH to 7.2-7.6 (e.g., with CTX-10 or CTX-20).

Additional dosing: with properly maintained pH, 1 g/m3 of water so that the free chlorine content does not exceed 0.6/m3 (for children's pools 0.3 g/m3). Check the free chlorine content daily using a test kit (pH+Cl).bsa

Initial dosing should be repeated at the first signs of water turbidity.

 

Application:

dissolve the required amount of CTX-200/GR in a plastic container with water and evenly distribute over the entire surface of the pool. Then run your filtration system for about 8 hours.

 

WARNING: During the product application and the following 8 hours, no one may be present in the pool. The product can be used only for pools with a filtration unit. After applying the product, it is necessary to check the free chlorine concentration in the water with a test kit (e.g., ref. no. 03253). If the free chlorine content is higher than 0.6 g/m3, wait and use the pool only after its value drops to or below the stated level. For all pools, the water should be regularly replaced to prevent increased mineralization and cyanuric acid content. The recommended cyanuric acid concentration is 35 g/m3 (check with a tester or photometer). Regularly also measure the bound chlorine (chloramines) content and when its concentration is 0.3 g/m3 or higher, perform superchlorination using CTX-200/GR (multiply the measured bound Cl in g/m3 of water by ten, max. 15 g/m).